Your TV receives signals from the video player (VCP) like another TV station. You have to select a channel number on your TV and tune it in so that you may watch video tapes. If you connect a monitor or a TV set equipped with AUDIO and VIDEO sockets this adjustment will not be necessary, simply select the AV mode on your TV.
Tuning in a Video channel On your TV
1
Make sure that you have correctly installed your VCP as described earlier in this book. Press STANDBY/ON to turn on your VCP.
2
Insert a pre-recorded video tape into your VCP and press PLAY.
3
Store the selected TV channel on your TV. (You will need to look at the TV instruction book if you do not know how to do this.)
Changing the transmitter channel
If channel 32 is already occupied at your TV set, or if the picture is distorted, you can change the transmitter channel of the VCP. Select an undistorted channel between 32 and 40 on your TV set and store it. Use a small screwdriver to turn slowly the CHANNEL selector on the back of your VCP, until you are satisfied with the picture quality.
EW PLAY
FF
REC
REC REW FF
PLAY
CST.IN A.REPEAT LP
To watch TV programs, turn off your VCP. When your VCP is on, broadcast reception through Turn on your TV. the AERIAL socket is not possible.
STANDBY/ON STOP/ EJECT P/STILL
POWER REW PLAY STANDBY
FF
REC
CST.IN A.REPEAT LP
Select channel 32 on your TV. And then you will see the picture being played in your VCP.
